News
Home / Joya News / Tips for Removing Adhesive Residue From Carpet

Tips for Removing Adhesive Residue From Carpet

  • Update:28-11-2016
  • Abst:

    Whenever using adhesive surface protection products on […]

    Whenever using adhesive surface protection products on a job site often there is a tiny risk of adhesive transfer. Improper set up, high temperatures, high traffic, and surpassing the advised 'remove by' date can all cause difficulties with carpet masks and films. Pursuing are a few tips to avoid any clammy transfer.

    Always follow the manufacturer's tips when using carpet films. Carpet film consumption ratings cover anything from 40 to 60 days. Going out of the film on floor coverings past the recommended use rating invalidates all manufacturers' warranty.

    Use films made in the USA for the best warrantee security and highest quality.

    Carpeting films use either drinking water based or solvent centered adhesives. Water based glues are better to remove when a problem occurs.

    Never set up adhesive carpet protection on wet or damp carpet.

    Never install adhesive carpet protection over glue down carpet for a minimum amount of 72 hours to allow the glue to "breathe".

    If carpet has been installed over the recently poured cement slab that is not fully healed, avoid adhesive carpet safeguard as it could trap the concrete floor moisture and discolor the carpet.

    In cases of extreme heat, shorten the recommended time of software by 50%.

    As explained on the installation instructions of each and every film manufacturer, there is no warrantee offered for application on made of woll carpets.

    If the above steps are taken, the possibility of any adhesive copy when by using a carpet film is negligible. In the cases where steps have NOT been followed, one of these two issues may occur: 1) gross adhesive residue on carpet, or 2) discoloration of carpet where the plastic material utilized. It is important at this step to find out the sort of adhesive used, drinking water or solvent based.

    Normal water based adhesive film deposit easily removes with hot water and can be quickly removed via steam cleaning the carpets. Solvent structured adhesive residue can also be removed via steam cleaning nonetheless it may take more than one cleaning to totally remove the adhesive. Citrus purifiers available at any hardware store will often aid in the removal of Solvent Based Adhesive residue. In the event that further problems persist, contact your local surface safety supplier to talk about other potential solutions.

    Discoloration of carpet is caused by the trapping of moisture under the film and the subsequent reaction of the moisture and the chemicals in the plastic film. Unfortunately this situation can only be remedied by removal of the damaged area of carpet. This kind of situation occurs most commonly in cases where users have carpeted over slabs which were not fully healed.

    Adhesive carpet films are a great time conserving surface protection product when used correctly. Users choosing high quality, USA made products and following the manufacturers' advice fully should never face a problem.